According to my trusted source, Wikipedia, it is estimated that there was spend more than 500 billion dollars on advertising in 2010. Now as a “middle aged man”(Also according to Wikipedia) I would like to believe that this expensive, but rather often simple propaganda are below my intelligence for having much effect.
I will have to admit that a casual flipping through one of my favorite trade magazines, the advertising agent did a fabulous job grabing my attention and fully direct it to their ad.
Can you make this part?
Well there I am, kids are screaming of hunger, the dog needs go outside, and I am sitting studying an advertising showing something that is suppose to pretend to look like a manufacturing quote, silently saying to myself, Sure I can!
So I decided to record a couple of videos. One creating this part in SolidWorks, and then follow up with one that machines that SolidWorks part using CAMWorks right inside SolidWorks. But before we go any further it might be in its place to discover who MFG.com is in case you are not familiar with this online tool. Explaining that the easiest and proably most accurate is to direct you to about MFG.com on their website.
Can you make this part using SolidWorks?
Can you make this part using CAMWorks?
Conclusion… So that part was not that hard. Of course we could do that part in SolidWorks and CAMWorks. If the part had been too hard I would probably never went this far. The magic of good advertising :-).
Kommentare